Vehicle owner's manual Chevrolet Tahoe 2 and 3

Parking system (modifications)
The parking system warns the driver about obstacles when parking the car. Sensors are installed on the rear bumper that register obstacles when reversing. The...

Parking brake
1. To apply the parking brake, press the brake pedal with your right foot until it stops. Press the parking brake pedal with your left foot. Note: If you start...

Driving a car with automatic transmission
To control the automatic transmission, a selector is mounted on the steering column. The selector is connected to the valve block by a cable, and with its help...

Automatic Variable Shock Absorber System (RSS)
The RSS system automatically changes the damper stiffness to provide optimum vehicle suspension performance depending on driving conditions and vehicle load...

Anti-lock braking system (ABS)
Caution: Use tires of the same size, construction and load capacity as the original vehicle tires, as using a different type of tire may interfere with the...

Traction Control System (TAS) (Chevrolet Tahoe)
The traction control system (TAS) is designed to automatically prevent wheel slip during acceleration and driving on slippery surfaces and ensures stable...

StabiliTrak stability control system
The StabiliTrak system controls the ABS, TCS and ASC systems, maintaining the vehicle's directional stability and traction. Traction Control System (TCS) 1....

Tire pressure monitoring system
Each wheel valve has a built-in pressure sensor that continuously measures the tire pressure and sends a corresponding signal to the tire pressure monitoring...

Features of the transmission of 4WD models
Attention: To avoid damage to transmission components, partial loading of 4WD models is prohibited (by raising only one of the vehicle's axles). Use tires of...

Rear Wheel Steering (WS) System
4WS system (rear wheel steering system) is designed to improve the vehicle's handling and maneuverability. The system has three operating modes: "2WS" mode;...

Tips for driving in different conditions
General recommendations Attention: Before driving, make sure that the parking brake is released and the corresponding indicator goes out. Do not keep your foot...

Towing a car
Cadillac Escalade Warning: it is strictly forbidden to tow 4WD vehicles using the partial loading method, i.e. by raising one of the vehicle axles. Towing your...

Towing a trailer
Although towing a trailer will have a negative effect on handling, performance, braking, durability and fuel economy, your vehicle may be used as a towing...

Starting the engine
Ignition switch There are four fixed positions of the ignition switch: LOCK: In this position, you can insert or remove the key from the ignition switch. When...

Engine malfunctions while driving
Engine stops while driving 1. Reduce speed gradually. Move the car to a safe place. 2. Turn on the hazard warning lights. 3. Try to start the engine. Note:...

Jack and tools
Cadillac Escalade The jack and tools are stored in a special compartment in the left trim panel of the rear side of the body. 1 - tool kit, 2 - bracket, 3 -...

Spare wheel
Removal the spare wheel. 1 - spare wheel, 2 - gearbox, 3 - gearbox rod, 4 - spare wheel holder, 5 - gearbox shaft, 6 - end of jack handle extension, 7 -...

Jacking up a car
1. Place the vehicle on a level and firm surface. 2. Apply the parking brake. 3. Stop the engine, apply the parking brake and set the selector to position "P"....

Wheel replacement
1. If you need to change a tire on the road, gradually reduce speed and move the car to a safe place. 2. Stop the vehicle on a level place with firm ground. 3....

Recommendations for choosing tires
When choosing tires, pay attention to the marking. The geometric dimensions, load capacity and maximum speed must strictly comply with the manufacturer's...

Checking tire pressure and condition
1. Check your tires regularly for damage. Check your tire pressure every two weeks or at least once a month. Don't forget to check the pressure in your spare...

Tire replacement
1. When replacing tires, use only tires of the same size and design as those originally installed, and with the same or greater load capacity. Using a tire of...

Features of using aluminum wheels
Caution: To avoid damaging the protective varnish layer, do not allow tire shop workers to clean the outer surface of the rim with a wire brush or remove...

Replacement of wheel disks
1. Due attention should be paid to replacing wheel rims. Make sure that rims with the same load capacity, diameter, rim width and offset are installed. 2....

Brake pad wear indicators
The brake pads for disc brakes are equipped with wear indicators in such a way that when driving, when the thickness of the pads is minimal, the wear indicator...

Catalytic converter and exhaust system
1. The catalytic converter is a device for reducing the toxicity of exhaust gases. When operating a vehicle equipped with a catalytic converter, observe the...

Checking and replacing fuses
If the headlights or other electrical components do not work, check the fuses. If any of the elements are burnt out, they must be replaced. Note: Use a special...

Replacing lamps in lighting fixtures
Attention: Before replacing a light bulb, make sure the light switches are turned off. To avoid burns, replace lamps only after they have cooled down. Halogen...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3 (2000-2014)