Car transfer case Chevrolet Tahoe 2 and 3

Transfer case component locations
Transfer case NVG 236/246 NP8. 1 - Engine wiring harness, 2 - Transfer case wiring harness connector C350, 3 - Transfer case mode shift motor, 4 - Vehicle...

Removal and installation the transfer case
NVG 236/246 NP8 Box, Early Models 1. Raise the vehicle. 2. Remove the transfer case guard, if installed. 3. Remove the front propeller shaft. 4. Remove the...

Checking the oil level and changing it
The procedures for checking the level and changing the oil in the rear differential are described in Chapter " Maintenance and general check and adjustment...

Input shaft seal
Removal 1. Raise the vehicle. 2. Remove the transfer case. 3. Remove the transfer case input shaft seal. Installation Note: When installing, the seal number...

Output shaft seal — front
Removal 1. Remove the transfer case guard. 2. Remove the front propeller shaft. 3. Insert a flat-head screwdriver under the inner ring of the oil seal. 4....

Output shaft seal — rear
Removal 1 Remove the transfer case guard. 2. Remove the rear propeller shaft. 3. Remove the output shaft rear oil seal. 4. Inspect the rear oil seal bushing...

Mode switching electric motor
Removal 1. Raise the vehicle. 2. Remove the transfer case protection. 3. Remove the front propeller shaft. 4. Disconnect the shift motor wiring connector. 5....

Transfer case control unit
Early models 1. Remove the instrument panel bezel. 2. Pull out the light switch, transfer case control buttons, courtesy lamp and air deflector louvers. 3....

Transfer case control switch
Early models 1. Remove the instrument panel bezel. 2. Slide the side clips off the switch block and pull out the switch block. 3. Installation is carried out...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3 (2000-2014)