Mode switching electric motor (Chevrolet Tahoe 2)

Removal

1. Raise the vehicle.

2. Remove the transfer case protection.

3. Remove the front propeller shaft.

4. Disconnect the shift motor wiring connector.

5. Unscrew the electric motor mounting bolts.

Box NVG 236/246 NP8

Box BW4482-NR4

6. Remove the electric motor.

7. Remove and discard the motor gasket (if installed).

Installation

Caution: If the electric motor is being replaced due to a fault, place the transfer case in neutral by manually shifting it before installing the new electric motor.

1. Install a new motor gasket. If there is no gasket, apply sealant to the threads of the motor mounting bolts.

2. Install the electric motor in place firmly by hand.

3. Tighten the mounting bolts. The tightening sequence of the bolts on the NVG 236/246 NP8 box is shown in the figure.

3. Tighten the mounting bolts. The tightening sequence of the bolts on the NVG 236/246 NP8 box is…

Tightening torque: NVG box 236/246 NP8 20 Nm; box BW4482-NR4 10 Nm.

4. Connect the wiring connector.

5. Install the front propeller shaft.

6. Install the transfer case guard.

7. Lower the vehicle.

[The article is based on data from the website «chevyman.ru»]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Transfer case

Output shaft seal — rear
Output shaft seal — front
Input shaft seal
Checking the oil level and changing it
Removal and installation the transfer case

Transfer case control unit
Transfer case control switch