Automatic transmission 6L50, 6L80, 6L90 car Chevrolet Tahoe 2 and 3
Main parameters of automatic transmission
Table. Basic parameters of automatic transmission Parameter Models from 2007 (GMT 900) Pro Codes MYC Manufacturer Ypsilanti, Michgan Gear ratios: 1 gear 4,027...
Table. Basic parameters of automatic transmission Parameter Models from 2007 (GMT 900) Pro Codes MYC Manufacturer Ypsilanti, Michgan Gear ratios: 1 gear 4,027...
Automatic transmission replacement
1. Disconnect the cable from the negative terminal of the battery. 2. Jack up the car and place safety stands under the frame. 3. Disconnect the rear propeller...
1. Disconnect the cable from the negative terminal of the battery. 2. Jack up the car and place safety stands under the frame. 3. Disconnect the rear propeller...
Replacement of working fluid and filter
Caution: If the automatic transmission fluid is at operating temperature, take precautions to prevent burns from the fluid. Caution: Use only DEXRON VI fluid....
Caution: If the automatic transmission fluid is at operating temperature, take precautions to prevent burns from the fluid. Caution: Use only DEXRON VI fluid....
Output shaft seal
Note: The inner surface of the crankcase extension must be dry. If there is working fluid in the extension, replace the output shaft seal. 1. Jack up the...
Note: The inner surface of the crankcase extension must be dry. If there is working fluid in the extension, replace the output shaft seal. 1. Jack up the...
Engine start inhibit switch seal
1. Jack up the vehicle and place safety stands under the frame. 2. Remove the gearbox. 3. Remove the working fluid pan. 4. Remove the valve block. 5. Using...
1. Jack up the vehicle and place safety stands under the frame. 2. Remove the gearbox. 3. Remove the working fluid pan. 4. Remove the valve block. 5. Using...
Automatic transmission control cable — removal and installation
Removal 1. Move the automatic transmission selector to position "P". 2. Remove the instrument panel knee support (see chapter " Body "). 3. Remove the driver's...
Removal 1. Move the automatic transmission selector to position "P". 2. Remove the instrument panel knee support (see chapter " Body "). 3. Remove the driver's...
Automatic transmission control cable — adjustment
Adjustment 1. Make sure that the automatic transmission selector on the steering column is in the "P" position. 2. Jack up the car and place safety stands...
Adjustment 1. Make sure that the automatic transmission selector on the steering column is in the "P" position. 2. Jack up the car and place safety stands...
Engine start inhibit switch
Removal Note: Before carrying out any work, disconnect the cable from the negative terminal of the battery. Installation is carried out in the reverse order of...
Removal Note: Before carrying out any work, disconnect the cable from the negative terminal of the battery. Installation is carried out in the reverse order of...
Automatic transmission input/output shaft speed sensors
Removal and installation 1. Jack up the vehicle and place safety stands under the frame. 2. Remove the automatic transmission fluid pan and filter. 3. Remove...
Removal and installation 1. Jack up the vehicle and place safety stands under the frame. 2. Remove the automatic transmission fluid pan and filter. 3. Remove...
Electromagnetic valve block and automatic transmission control unit
Removal and installation Note: Before carrying out any work, disconnect the cable from the negative terminal of the battery. Installation is carried out in the...
Removal and installation Note: Before carrying out any work, disconnect the cable from the negative terminal of the battery. Installation is carried out in the...
This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
See similar sections on Chevrolet cars:
Transmission: Automatic gearbox Chevrolet Aveo T200 (2003-2008)
Transmission: Automatic gearbox Chevrolet Lumina 1 (1989-1994)
Transmission: Automatic gearbox Chevrolet Aveo T200 (2003-2008)
Transmission: Automatic gearbox Chevrolet Lumina 1 (1989-1994)
Share information:
- General information
- Vehicle characteristics
- Vehicle device
- Manual
- Maintenance
- Power unit
- Engine repair
- Engine overhaul
- Cooling system
- Injection and control system
- Exhaust system
- Engine electrical equipment
- Transmission
- Automatic gearbox 4L60, 4L65, 4L70
- Automatic gearbox 6L50, 6L80, 6L90
- Transfer case
- Drive shafts and cardan
- Front drive axle
- Rear drive axle
- Chassis
- Car suspension
- Steering
- Brake system
- Body (until 2007)
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Heating and air conditioning
- Security System (SRS)
- Body (since 2007)
- Exterior (external elements)
- Doors, locks and windows
- Interior (internal elements)
- Electrical equipment
- Electrical appliances (until 2007)
- Lighting and lamps (until 2007)
- Audio system (until 2007)
- Electrical appliances (since 2007)
- Lighting and lamps (since 2007)
- Audio system (since 2007)
- Wiring diagrams (2000-2005)
- Wiring diagrams (2005-2007)
- Wiring diagrams (since 2007)
- General information
- User manual
- Maintenance
- Power unit
- Engine in a car
- Engine removed
- Cooling system
- Heating and air conditioning
- Fuel and exhaust systems
- Decreased toxicity
- Transmission
- Manual gearbox
- Automatic gearbox
- Transfer case
- Clutch and drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Repair of body elements
- Electrical equipment
- Engine electrics
- Equipment and devices
- Electrical circuits