Contents: Removal ↧ Installation ↧
Removal
1. Move the automatic transmission selector to position "P".
2. Remove the instrument panel knee support (see chapter "Body").
3. Remove the driver's seat.
4. Lift up the carpet and insulation around the driver's seat area.
5. Remove the cable retainer from the steering column.
6. Remove the cable end from the steering column arm ball joint.
7. Squeeze the clamps and remove the cable from the steering column bracket.
Caution: When removing and installing, avoid unnecessary twisting or bending of the automatic transmission control cable.
8. Remove the cable from the support.
9. Remove the cable sealing ring from the floor panel.
10. Jack up the car and place safety stands under the frame.
11. Disconnect the cable support clips from the floor panel reinforcement.
12. Make sure that the starter inhibit switch lever is set to the park position.
13. Disconnect the cable support clip on the transfer case (if available).
14. Disconnect the end (2) of the control cable from the cable ball joint on the inhibition switch lever.
15. Remove the cable support clamp (1).
16. Squeeze the cable clamps and remove the cable from the bracket.
17. Remove the cable.
Installation
18. Installation is carried out in the reverse order. When installing, make sure that the shift shaft on the automatic transmission and the automatic transmission selector are in the "P" position.