Technical data (dimensions and clearances in mm) Disc brakes Lateral runout of the disc - 0.1 Disc Thickness Limit - Molded on Disc Irregularity of the disc in thickness - 0.05 Drum brakes Maximum diameter of...
General information about brakes Vehicles are equipped with hydraulic brakes with hydrovacuum brake boost. On all the cars in question, the front brakes are disc, the rear brakes are drum. The...
Disc brake pads — replacement Attention! Brake pads are changed only as a set for one axle. When cleaning the pads, dust and dirt should be removed by wiping with a rag soaked in denatured...
Brake disc — check, removal and installation 1. Loosen wheel nuts, raise vehicle and place on stands. Remove wheels. 2. Remove the caliper, move aside and secure. Check the condition of the disk on both...
Brake caliper — removal and installation Attention! For serious damage (leak from the cylinder, seizure of the piston, etc.) the caliper is recommended to be replaced. 1. Loosen wheel nuts, raise...
Parking brake — adjustment 1. The parking brake is pedal operated. The tension of the parking brake cable is automatic, provided by the regulator in the rear brake mechanism. However,...
Parking brake cable — removal and installation 1. Release the parking brake. 2. To remove the front cable, unscrew the adjusting nuts on the leveling bar and disconnect the cable (see photo). 3. Remove the...
Vacuum brake booster — removal and installation 1. The vacuum brake booster does not require special maintenance, except for periodic inspection of the vacuum hoses and housing. 2. Dismantling of the unit,...
Power brake booster — removal and installation 1. With the engine stopped, depress the brake pedal several times to release pressure from the accumulator. Remove the master cylinder together with the valve...
Hydraulic hoses and tubes — check and replace 1. The condition of hoses and tubes is recommended to be checked every 6 months. If cracks, leaks, swelling or other damage are found, replace the hose....
Removal of air from a hydraulic drive of brakes 1. The need to bleed the brakes occurs after the pipes of the master or wheel cylinder are disconnected, or when the level in the reservoir drops significantly...
Anti-lock braking (ABS) system — general information The vehicles are equipped with an automatic brake release system (ABS system), designed to improve vehicle stability under heavy braking conditions. The...