Brake system of the car Chevrolet Lacetti 1

The structure of the braking system
Elements of the car braking system: 1 - master brake cylinder; 2 — hydraulic reservoir; 3 - brake fluid level sensor; 4 - vacuum booster; 5 — pedal assembly...

Replacing the front brake pads
We replace the brake pads in the event of the maximum permissible wear of their linings - the minimum thickness of the pad, including its base, must be at...

Replacement of protective covers and sealing rings of pistons of brake cylinders of front and rear wheels
We replace the piston protective cover if it is damaged - cracks, rubber ruptures or loss of elasticity of the cover. We replace the sealing ring if there are...

Replacing the brake pads of the rear wheels
We replace the pads in case of the maximum permissible wear of their linings - the minimum lining thickness should be at least 2 mm. The pads must also be...

Removal the front wheel brake disc
We carry out the work when replacing a disc, as well as when dismantling a wheel hub or steering knuckle. The brake disc thickness must be at least 22.0 mm. If...

Removal the rear wheel brake disc
We carry out the work when replacing the disc, the pads of the parking brake mechanism, and also when removing the rear wheel hub. The thickness of the brake...

Replacing the parking brake pads
We replace the brake pads if their linings are oily, if there are chips on them, or if the linings have separated from the base of the pads. We show the...

Removal the master brake cylinder
We carry out the work when replacing the main brake cylinder and removing the brake booster. By pressing the block retainer, we disconnect the block of wires...

Removal the brake booster
We remove the brake booster for replacement in case of its failure. Disconnect the wiring harness from the working fluid level sensor (see Removal the master...

Replacing the front brake hose
We replace the brake hose if it has mechanical defects - abrasions, cracks or tears, as well as if a leak of brake fluid is detected through the hose or if...

Replacing the rear wheel brake hose
We replace the brake hose if it has mechanical defects - abrasions, cracks or tears, as well as if a leak of brake fluid is detected through the hose or if...

Removal the parking brake system components
Parking brake cables are replaced if they break, stretch, or become jammed inside the casings, when adjusting the parking brake does not allow the vehicle to...

Removal the ABS unit
We remove the ABS unit for replacement if it fails. We remove the expansion tank without disconnecting the hoses from it (see Removal the expansion tank ), and...

Removal wheel speed sensors
We show the removal of the front wheel speed sensors, since the rear wheel speed sensors are built into the rear wheel hubs and are removed only together with...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: