Electrical equipment and devices of the car Chevrolet Lacetti 1
Electrical equipment of a car The on-board network is direct current, with a nominal voltage of 12 V. The electrical equipment is made according to a single-wire scheme: the negative...
Replacing fuses and relays We carry out the work when fuses and relays fail. When removing fuses and relays, be sure to disconnect the wire terminal from the negative terminal of the...
Removal the sound signal We remove the sound signal for replacement and for adjustment when the sound of the signal becomes hoarse or quiet. The signal is located behind the front...
Removal the windshield wiper We remove the windshield wiper to replace the failed motor-reducer and windshield wiper linkage rods. Disconnect the wire terminal from the negative terminal...
Removal the tailgate glass wiper We remove the windshield wiper of the luggage compartment door to replace the failed motor-reducer. Disconnect the wire terminal from the negative terminal of...
Removal the windshield and tailgate glass washer pump We carry out the work in case of pump failure and damage (leaks) windshield washer reservoir. Disconnect the wire terminal from the negative terminal of the...
Removal the instrument cluster, replacing the bulbs We carry out the work when replacing the instrument cluster, control lamps or instrument lighting lamps. Instrument cluster: 1 - control lamps; 2 — instrument...
Removal the airbag control unit We carry out the work when replacing the driver and front passenger airbag control unit. Disconnect the wire terminal from the negative terminal of the...
Removal the front speakers of the audio system We carry out the work when replacing speakers. Low-frequency speakers are installed in the front doors, and high-frequency speakers are in the decorative...
Removal the rear speakers of the audio system We carry out the work when replacing speakers. The speakers are installed in the rear doors. To replace the speaker, remove the rear door trim (see Removal the...
Removal the brake light switch We carry out work to check and replace the switch. The switch is mounted on the brake pedal bracket under the instrument panel. Disconnect the wire terminal...
Removal the hazard warning switch We are carrying out the work to replace the switch backlight lamp and the switch itself. The switch is installed on the central trim panel of the instrument...
Removal the central locking control unit We are carrying out work to replace the block. The unit is mounted on the floor tunnel underneath the rear of the floor tunnel lining. Disconnect the wire...
Removal the watch We carry out the work to replace the clock and when removing the instrument panel. Disconnect the wire terminal from the negative terminal of the battery. We...
Removal the head unit of the audio system We carry out the work to replace the head unit and when removing the instrument panel. Disconnect the wire terminal from the negative terminal of the battery....