Removal the hazard warning switch (Chevrolet Lacetti J200)

We are carrying out the work to replace the switch backlight lamp and the switch itself.

The switch is installed on the central trim panel of the instrument panel.

Disconnect the wire terminal from the negative terminal of the battery. Remove the central instrument panel trim (see Removal the heating, ventilation and air conditioning control unit).

Disconnect the wire terminal from the negative terminal of the battery. Remove the central…

By pressing the locking device of the wiring harness connector, we disconnect the connector from the switch.

We remove the switch from the hole in the central cover.

Using a screwdriver, turn the lamp counterclockwise.

We remove the backlight lamp from the switch.

We install the backlight lamp and the hazard warning switch in the reverse order.

[The article was borrowed from the website «ChevyMan.ru»]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Lacetti 1: Equipment and devices

Removal the headlight beam direction and instrument and control illumination brightness regulator unit
Removal the brake light switch
Removal the rear speakers of the audio system
Removal the front speakers of the audio system
Removal the airbag control unit

Removal the central locking control unit
Removal the watch
Removal the head unit of the audio system