Car transfer case Chevrolet Tahoe 1

Tightening torques for connections (Nm)
Transfer case shaft cardan joint yoke nuts: On the New Process/New Venture transfer case - 138 On the Borg Warner transfer case: Front fork - 200 Rear fork -...

General information about the transfer case
All-wheel drive (4WD) models are equipped with a transfer case, which is mounted at the rear of the transmission. Torque is transmitted from the engine through...

Transfer case engagement rod — checking and adjustment
1. Move the transfer case engagement lever in the cab to the 4-HIGH position. 2. Raise the vehicle and place it on stands. 3. Disconnect the rod from the...

Transfer case engagement lever — replacement
1. Remove the handle from the lever (see photo). 2. Loosen the screws of the floor section and remove the floor section. Disconnect the control lamp wires (see...

Replacing the oil seal
Caution! The procedure is the same for the transfer case front shaft seal and the transmission tailstock seal. 1. Raise the vehicle and place it on stands. 2....

Transfer case — removal and installation
1. Disconnect the battery from ground. 2. Raise the vehicle and place it on stands. 3. On some vehicles, remove the gearbox shield. 4. Drain the oil from the...

Transfer case overhaul (only for New Process 241 gearbox)
1. Remove the transfer case. 2. Clean the transfer case. External details 3. Unscrew the front flange nut, remove the washer, rubber seal and front flange. 4....

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3 (2000-2014)