Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Tahoe 2 and 3 (2000-2014) Tahoe 1 (1992-2000)

Battery — Removal and Installation (Chevrolet Tahoe 1)

1. Disconnect both cables from the battery.

2. Remove the pressure plate (see photo).

2. Remove the pressure plate (see photo).

2. Remove the pressure plate (see photo).

2. Remove the pressure plate (see photo).

3. Remove the battery.

4. Installation is carried out in reverse order.

(The article is based on data from the website ChevyMan.ru)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Tahoe 1: Engine electrics

Next articles

Ignition System — General Information and Precautions

Ignition system — check
Ignition distributor — removal and installation
Electronic Ignition Module (Pre-1995 Models) — Replacement
Induction ignition sensor (before 1995) — checking and replacement
Ignition Coil — Checking and Replacing

See similar articles on the topic of Chevrolet cars:
The battery is not recharging Chevrolet Aveo T300 (2012-2018)
Rechargeable battery Chevrolet Captiva 1 (2006-2018)
The battery is not recharging Chevrolet Cruze 1 (2008-2016)
Starting the engine from another car's battery («jump-starting») Chevrolet Lacetti 1 (2002-2009)
Starting the engine from another car's battery (jump-starting) Chevrolet Lanos T150 (2002-2009)
Battery Chevrolet Niva 1 (2002-2016)
Check, service and charge the battery (every 3000 miles or 3 months) Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.