2. Remove the drive belt.
3. Press the power steering pump pulley off the pump shaft using a puller (see photo).
4. Disconnect the discharge pipe and drain hose from the rear of the pump (see photo).
5. Loosen the bolts and remove the pump (see photo).
6. Install the pump into the mounting bracket, insert the bolts and tighten the nuts, tighten the nuts.
7. Attach the tube and hose to the pump. Tighten the fitting nuts.
8. Press the pulley onto the pump shaft using a tool consisting of a bolt, nut and a piece of pipe (socket head) (see photo). The pulley hub should be flush with the end of the shaft.
9. Install the drive belt.
10. Fill the power steering pump reservoir with fluid and bleed air from the hydraulic system.
Original version of the article on the website «ChevyMan»