Car steering Chevrolet Lumina 1

General information about steering
Attention! Each time the steering components are removed, they must be checked and, if necessary, replaced with new ones of the same number, quality and...

Removal and installation tie rod ends
Removal 1. Loosen the wheel nuts, lift the front of the car and securely fasten it to the stands. Set the vehicle's parking brake and block the rear wheels to...

Removal and installation the steering gear
Removal 1. Disconnect the cable from the negative terminal of the battery. 2. Loosen the front wheel nuts, raise the front of the vehicle and securely support...

Replacing protective covers
1. Remove the steering gear from the vehicle ( see section 17 ). 2. Remove the tie rod ends ( see section 16 ). 3. Remove the lock nuts and outer clamps of the...

Removal and installation the power steering pump
Removal 1. Disconnect the cable from the negative terminal of the battery. 2. Remove the pump drive belt ( see chapter 1 ). 3. Place a container under the...

Bleeding the power steering
1. After any operation in which the hydraulic fluid lines were disconnected, it is necessary to bleed the power steering system to remove air. 2. With the...

Removal and installation the steering wheel
Warning! Performing the following procedure on 1994 vehicles is dangerous! These vehicles are equipped with an airbag on the steering wheel. Do not attempt to...

This section is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information: