You will need: a flat-blade screwdriver, a 10 mm wrench.
To remove the air filter housing, follow these steps:.
1. Loosen the clamp securing the air supply hose to the air filter housing...
2. ...and disconnect the hose from the air filter housing pipe.
Please note: the air filter pipe and the edge of the air supply hose have a cutout and a protrusion for correct installation of the hose.
3. Press the latch...
4. ...and disconnect the power steering hose from the bracket on the air filter housing.
5. Lift up and remove the front...
6. ...and the rear air filter holders from the brackets on the body.
7. Lift up and remove the intake air temperature sensor wire harness holder from the bracket on the air cleaner housing cover.
8. Disconnect the wiring harness connector from the intake air temperature sensor.
9. Remove the air filter by removing the pipe located at the bottom of the filter housing from the air duct neck of the intake silencer.
This is what an air filter looks like when removed from a car.
10. Install the air filter in the reverse order of removal.
To remove the intake noise muffler and the air duct, do the following.
1. Remove the right front wheel and place the front of the vehicle on a secure support.
2. Remove the right front fender liner.
3. Overcoming the resistance of the three holders securing the muffler to the body, move the muffler away and remove it.
4. Install the parts in the reverse order of removal.
The material was created based on information from the website: ChevyMan