Removal the rear door lock (Chevrolet Lacetti J200)

We carry out the work when replacing the lock, external and internal door handles.

Remove the door trim (see Removal the rear door trim) and glass (see Removal the rear door glass).

Disconnect the outer door handle (see Removal the outer rear door handle) and an internal handle (see Removal the inner rear door handle).



Using a screwdriver, we successively press down the four antennae of the lever axis.



We remove the lever from the axle.



In the door cavity, use a screwdriver to release the lock of the lower end of the rod (for clarity, shown on a removed unit).





We open the lock and release the rod.



After releasing the lock, we remove the wiring block from the electric lock connector.



We remove both longitudinal door rods from the holders.



Using a 10 mm head, unscrew the nut of the lower rear guide mount.





Using a Torx-T30 key, unscrew the three screws securing the lock



We take the pin of the rear door glass guide out of the hole and, applying a little force, move it a little further so that the upper rod can pass between the pin and the inner door panel. Having passed the rod, we take out the lock through the technological hole of the inner door panel.



View of the rear door lock and handles. Install the rear door lock in the reverse order.