Removal the lock, inner and outer handles of the rear door (Chevrolet Lanos T150)

We carry out the work when replacing the lock, outer and inner door handles. We remove the door trim (see Removal the rear door trim) and glass (see Removal the rear door glass).



Using a screwdriver, press the plastic traction lock…



…and disconnect the rod from the outer handle lever.



Using a 10 mm socket with an extension, unscrew the two bolts securing the outer handle…





…and remove the outer handle.



Using a screwdriver, press the plastic fasteners of the two rods of the inner handle..



…and disconnect them from the lock.



Using a Phillips screwdriver, unscrew the three screws securing the door lock.





After pressing the lock, we disconnect the wiring harness block from the electric drive of the lock.



We remove the lock through the technological hole in the inner door panel.



Using a Phillips screwdriver, unscrew the screw that secures the base of the inner handle…



…and, moving the base forward, we remove its tabs from the holes in the inner door panel.





We remove the inner handle together with the rods.

To disconnect the rods from the inner handle…



…we turn the handle over and disengage the rods from the levers.



Rear door lock with electric locking drive, outer and inner handles

We install the lock and door handles in the reverse order

The article was borrowed from the website ChevyMan