The work is shown on the right headlight, the left headlight is removed in the same way.
Disconnect the wire terminal from the negative terminal of the battery.
By pressing the lock, we disconnect the wiring block from the headlight connector.
By pressing the lock, we disconnect the wiring block from the turn signal lamp socket.
By squeezing the clamps, we disconnect the wiring block from the connector of the headlight beam direction adjuster motor.
Using a 10 mm socket, unscrew the nut and two bolts securing the headlight.
We remove the headlight unit with the decorative cover.
If the headlight is removed during body repair, the decorative trim does not need to be removed.
If the headlight is removed for replacement, then you need to remove the decorative cover from the headlight housing.
Using a Phillips screwdriver, unscrew the two screws securing the trim.
We remove the decorative cover from the headlight.
We install the headlight in the reverse order.
If a new headlight is being installed, it is necessary to install a decorative cover removed from the old headlight.
After installing the headlight, adjust the direction of the headlight beam (see Adjusting the direction of the headlight beams).
The article was borrowed from the website ChevyMan