Removal and installation the rear axle (Chevrolet Niva 1)

Removal and installation of the rear axle beam are described in subsection. "Rear suspension". To remove the rear axle, it is sufficient to disconnect the suspension rods and shock absorbers only from the rear axle beam. When installing the rear axle, tighten the rod mounting bolt nuts in accordance with the instructions in subsection. "Rear suspension". After installation, bleed the brake system and adjust the service and parking brake systems according to the instructions in the section "Brakes". Fill the rear axle with transmission oil through the oil filler hole.

[Original version of the article on the website: chevyman.ru]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Niva 1: Rear axle

Possible malfunctions, their causes and methods of elimination
Rear axle structure

Disassembly and assembly of the rear axle
Checking the rear axle beam
Rear axle beam straightening

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet