Removal the front section of the floor tunnel lining (Chevrolet Lacetti J200)

We remove the front part of the floor tunnel to access the gearbox control mechanism, the electrical outlet wiring block and when removing the instrument panel.



Remove the gear shift lever boot frame from the opening in the front of the floor tunnel.

Remove the rear part of the floor tunnel trim (see Removal the rear section of the floor tunnel trim).



Using a Phillips screwdriver, unscrew the two rear mounting screws



and two self-tapping screws for the front fastening of the tunnel lining (one on each side).





Having lifted the trim, we pass the lever cover through the hole.



Disconnect the wiring harness from the electrical outlet and remove the front part of the floor tunnel trim.

We install the front part of the floor tunnel lining in the reverse order.