To preserve the paintwork of the car body and keep it in good condition for a long time, it is necessary to select polishing agents that correspond to the condition of the coating. In this case, it is necessary to follow the recommendations for their use.
During the first 2-3 months of using the car, wash the body coating with cold water. To polish the new coating (up to 3 years) use non-abrasive polishes for new finishes.
When using a car for 3 to 5 years, use car polishes for weathered surfaces that contain a small amount of abrasives. After 5 years of intensive use, use car polishes for old surfaces.
To prevent the polish from drying out, polish the body in small sections by hand with a clean flannel.
To eliminate minor defects of the paintwork, polishing pastes PMA-1 or PMA-2 can be used. Polishing can be done manually or mechanically with flannel or lambskin circles.
Before use, stir the paste, if it thickens, dilute with water. After polishing, wipe the surface with a clean flannel.
(Information taken from the official website ChevyMan)
Polishing of paintwork (Chevrolet Niva 1)
The article was checked: Vladimir Romannikov
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Share information:
Previous articles
Niva 1: Exterior (external elements)
Next articles
Link in different formats to this page
Visitor comments
No comments yet
- General information
- Vehicle device
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling system
- Lubrication system
- Power and exhaust system
- Transmission
- Clutch
- Car gearbox
- Transfer case
- Cardan gear
- Rear axle
- Front axle
- Chassis
- Suspension and shock absorbers
- Steering
- Brake system
- Body
- Exterior (external elements)
- Interior (internal elements)
- Ventilation and heating
- Electrical equipment
- Power devices
- Lighting and appliances