- Disconnect the wiring harness connector from the purge solenoid valve;
- Disconnect hoses 1 and 5 from the adsorber;
- Unscrew bolt 8, loosen the clamp and remove adsorber 6.
Removal the adsorber (Chevrolet Niva 1)
The article was checked: Vladimir Romannikov
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Share information:
Previous articles
Niva 1: Power and exhaust system
Next articles
See similar articles on the topic of Chevrolet cars:
Removal, checking and installation the purge valve of the adsorber Chevrolet Aveo T300 (2012-2018)
Adsorber of the gasoline vapor recovery system (SUPB) in assembly Chevrolet Captiva 1 (2006-2018)
Removal, checking and installation the purge valve of the adsorber Chevrolet Cruze 1 (2008-2016)
Removal the purge valve of the adsorber Chevrolet Lacetti 1 (2002-2009)
Removal the purge solenoid valve of the adsorber Chevrolet Lanos T150 (2002-2009)
Removal, checking and installation the purge valve of the adsorber Chevrolet Aveo T300 (2012-2018)
Adsorber of the gasoline vapor recovery system (SUPB) in assembly Chevrolet Captiva 1 (2006-2018)
Removal, checking and installation the purge valve of the adsorber Chevrolet Cruze 1 (2008-2016)
Removal the purge valve of the adsorber Chevrolet Lacetti 1 (2002-2009)
Removal the purge solenoid valve of the adsorber Chevrolet Lanos T150 (2002-2009)
Link in different formats to this page
Visitor comments
No comments yet
- General information
- Vehicle device
- User manual
- Maintenance
- Power unit
- Engine repair
- Cooling system
- Lubrication system
- Power and exhaust system
- Transmission
- Clutch
- Car gearbox
- Transfer case
- Cardan gear
- Rear axle
- Front axle
- Chassis
- Suspension and shock absorbers
- Steering
- Brake system
- Body
- Exterior (external elements)
- Interior (internal elements)
- Ventilation and heating
- Electrical equipment
- Power devices
- Lighting and appliances