Removal the anti-roll bar (Chevrolet Lacetti J200)

We remove the stabilizer bar for replacement if it breaks or its ball joints are heavily worn.

We show the replacement of the right stabilizer strut, we replace the left strut in the same way.



Using a 14 mm open-end wrench, unscrew the nut on the lower ball joint pin of the strut, holding the pin from turning using a hex key of the same size.



We remove the ball joint pin from the hole in the stabilizer bar.



Using a 14 mm open-end wrench, unscrew the nut on the upper ball joint pin of the strut, holding the pin from turning using a hex key of the same size.



We remove the ball joint pin from the hole in the shock absorber strut bracket and remove the anti-roll bar strut.

We install the stabilizer bar in the reverse order.

Tighten the ball joint pin nuts to the specified torque (see Appendices).

[The original article is on the website: chevyman.ru]