Removal and installation axle shafts (Chevrolet Niva 1)

Remove the wheel and brake drum.

After unscrewing the nuts securing the brake shield to the axle beam, using the ejector 67.7823.9516, while holding the brake shield, remove the axle shaft together with the oil deflector, bearing mounting plate, bearing and bearing retaining ring.

If replacement is necessary, remove the seal from the beam flange.

Install the axle shaft in the reverse order of removal, being careful not to damage the working edge of the seal. Before installing the brake drum, lubricate the axle shaft seat with graphite grease or LSC-15 grease. After installation, check the operation of the axle shafts under road conditions.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Niva 1: Transfer case

Transfer case testing
Checking the technical condition
Disassembly and assembly
Removal and installation the transfer case
Methodology for determining the causes of vibration of the transfer case and the body floor (in the area of the front seats)

Checking the technical condition of the axle shafts
Axle shaft bearing retaining ring
Assembly of the axle shaft
Measuring the axial free play of the axle shaft on a vehicle
Rear axle gearbox device

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet