Pre-bend the holders 39 outwards (see figure 3-49) bolts securing plate 38 with the oil deflector and brake shield, and remove the bolts.
Using the half rings of the 67.7823.9571 tool, encircle the bearing and install the axle shaft vertically so that the half rings rest on the thrust ring.
Place the axle shaft under the press (figure 3-55) and apply gradually increasing force to the splined end of the axle shaft until the bearing retaining ring is removed. Do not reuse the axle shaft bearing retaining ring, but replace it with a new one.
Figure 3-55. Pressing out the axle shaft bearing retaining ring:
1 - device;
2 - half shaft.
Check that the axle shaft seating surface is free of scratches or damage; if necessary, replace the axle shaft with a new one.
(For details, visit the website «ChevyMan.ru»)