Note: The work is shown on the example of speakers installed in the left front door. Speakers in the right door are replaced in the same way.
For removal broadband speaker perform the following operations.
1. Disconnect the wire from the negative terminal of the battery.
2. Remove the front door trim (see "Removal and installation the front door trim").
3. Remove the speaker mounting bolt...
4. ...and remove the speaker from the door mounting panel opening.
5. Squeeze the clamps...
6. ...and disconnect the wiring harness connector.
7. Use a screwdriver to pry...
8. ...and remove the wiring harness retainer.
9. Remove the speaker.
10. Install the speaker and all parts in the reverse order of removal.
For removal high frequency speaker perform the following operations.
1. Disconnect the wire from the negative terminal of the battery.
2. Pry up the edge of the front pillar trim...
3. ...move the front pillar trim away, overcoming the resistance of its holders...
4. ...squeeze the retainer and disconnect the wiring harness connector from the tweeter.
Note: The tweeter is secured in the casing by melting the plastic on the edge of the mounting site. To remove the speaker, carefully trim the melted areas with a sharp knife.
When installing the speaker, restore the mounting points with a soldering iron.
5. Install the trim with the high-frequency speaker in the reverse order of removal.