Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Niva 1 (2002-2016)

Removal the shield and front wing cover (Chevrolet Niva 1)

Unscrew bolts 5 (figure 8-80) and remove the front wing shield with seals 4 as an assembly.

Figure 8-80. Removing the front fender shield and cover:

Figure 8-80. Removing the front fender shield and cover:
1 - screw;
2 - protective cover;
3 - front wing shield;
4 - seal;
5 - bolt.

Unscrew two screws 1 and remove protective cover 2.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Niva 1: Interior (internal elements)

Next articles

Removal car body upholstery
Replacement of rear door glass
Side glass replacement
Windshield installation
Removal and installation the windshield

Removal the shield and front wing cover for assembly 55
Removal and installation the gearshift lever and transfer case for the 55 configuration
Removal and installation the gearbox and transfer case handle inserts for the 55 configuration
Removal and installation the floor tunnel lining for assembly 55
Removal and installation roof trim for trim level 55

See similar articles on the topic of Chevrolet cars:
Front wing Chevrolet Aveo T250 (2006-2011)
Front engine cover Chevrolet Captiva 1 (2006-2018)
Removal and installation the front wing Chevrolet Cruze 1 (2008-2016)
Replacing the cylinder head cover gasket Chevrolet Lacetti 1 (2002-2009)
Replacing the protective cover and sealing ring of the front wheel brake piston Chevrolet Lanos T150 (2002-2009)
Front wing — removal and installation Chevrolet Tahoe 1 (1992-2000)
Replacing the front crankshaft oil seal Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.