Attention. For normal operation of the lighting and signaling system, use the lamps specified in Appendix 2. Before replacing the lamps in the headlamp, remove the protective cover 3, Figure 52, which is secured with a wire holder 2. To replace the low or high beam lamp, remove the connector 5, remove the spring latch antennae 6 from the grooves and remove the lamp 4.
To replace the turn signal bulb, turn socket 1 counterclockwise and remove it from the socket, turn and remove the bulb. To replace the side light bulb, remove socket 5 of the low beam headlights, pull the socket with the bulb out of the headlight unit, and remove the bulb.
Replace the bulbs in the rear light from the luggage compartment side, having first opened the valve in the luggage compartment side trim. To access the burnt-out bulb 1, Fig. 53, turn the socket 2 counterclockwise and remove it together with the bulb. To remove the bulb from the socket, press on the bulb and turn it counterclockwise.
In fog lamp 1, Fig. 54, replace the burnt-out bulb after removing the lamp from the car. To remove lamp 3, remove protective rubber cover 4 and remove the spring latch antennae 2 from the grooves. To make it easier to remove the lamp, first remove socket 5 from it.
In the interior light, Figure 55, replace the burnt-out lamp 2 by removing the diffuser 1, for which press your fingers in the center of the diffuser and pull it down. The lamp is held in the light by spring contacts.
Replace the burnt-out lamp 3, Figure 56, in the license plate light only after removing it from the car, for which unscrew the screws 6, insert a screwdriver into the groove 4, press the latch 5 towards the center with your finger and carefully remove the diffuser 2 with a screwdriver. The lamp in the housing 1 is held by spring contacts.
To replace the bulb in the side turn signal, Fig. 57, remove it from the car. The indicator is held in the socket by spring clips. Then remove the protective rubber cap 1, remove the socket with the bulb from the housing 2 and remove the bulb.
To replace the indicator lamps 1 and the lighting lamps 2 in the instrument cluster, Fig. 58, remove the shield and unscrew the mounting screws. Then pull the instrument cluster towards you and disconnect the wiring harnesses from the connectors 3. Turn the lamp to be replaced counterclockwise and remove it from the socket.
To replace a burnt-out bulb in the individual lighting lamp, you need to dismantle its switch. To do this, squeeze the switch from the sides, disengage the protrusions of the axis from the holes in the fixed part of the lamp, and then pull the switch down. To replace the bulb in the glove compartment light, remove it from the socket by carefully prying it from above with a screwdriver. Remove the base in the light by pressing the latch, replace the burnt-out bulb. Replacing the bulb in the trunk light is similar to replacing the bulb in the glove compartment light.
The article was borrowed from the website: chevyman