Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Orlando 1 (2010-2018) Trailblazer 1 (2001-2008, petrol) Lumina 1 (1989-1994)

Air Flow Sensor (MAF, 3.8 l) (Chevrolet Lumina 1)

52. Disconnect the electrical connector.

53. Remove the MAF sensor screws (see illustration) from the block.

13.53. Unscrew the screws (indicated by arrows) from the air flow sensor (MAF)

13.53. Unscrew the screws (indicated by arrows) from the air flow sensor (MAF)

54. Remove the MAF sensor.

Caution! The MAF sensor is a very delicate device. If you plan to put it back in its original location, handle it with care.

55. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Lumina 1: Fuel injection

Next articles

Fuel Pressure Regulator — Removal and Installation (3.8 L)
Fuel Injectors — Removal and Installation (3.8L)
Fuel distribution pipe — removal and installation (3.8 l)
Air manifold — removal and installation (3.8 l)
Throttle Position Sensor (TPS, 3.8L)

See similar articles on the topic of Chevrolet cars:
Combined mass air flow and intake air temperature sensor Chevrolet Aveo T300 (2012-2018)
Mass Air Flow (MAF) Sensor Chevrolet Captiva 1 (2006-2018)
Replacing the pressure sensor Chevrolet Cruze 1 (2008-2016)
Removal the low oil pressure sensor Chevrolet Lacetti 1 (2002-2009)
Checking the crankshaft position sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Air flow/air temperature sensor Chevrolet Tahoe 2 and 3 (2000-2014)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.