Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Rear wheel arch trim (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Release the rear wheel arch trim insert holders.

2. Remove the rear wheel arch trim from the vehicle.

2. Remove the rear wheel arch trim from the vehicle.

Installation procedure

1. Place the rear wheel arch liner into the vehicle.

2. Install the insert holders.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Exterior (external elements)

Next articles

Filler cap
General description of the rear part of the body
Front wing insulation
Front engine shield
Front wing — removal and installation

See similar articles on the topic of Chevrolet cars:
Removal and installation the rear wheel mudguard Chevrolet Aveo T300 (2012-2018)
Replacing the rear wheel hub Chevrolet Cruze 1 (2008-2016)
Removal the rear wheel brake disc Chevrolet Lacetti 1 (2002-2009)
Adjusting the rear wheel bearings Chevrolet Lanos T150 (2002-2009)
Removal and installation of front and rear wheel arch trims for assembly 55 Chevrolet Niva 1 (2002-2016)
Rear wheel arch liner Chevrolet Tahoe 2 and 3 (2000-2014)
Removal, repair and installation of the rear wheel brake cylinder Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.