Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Remove the front wheel arch liner. See "Front wheel arch trim" in this section.
2. Remove the bolts securing the front trim to the fender.
3. Install the front trim.
4. Remove the wing bolts behind the front trim.
5. Remove the threshold panel molding. See section 9M, "Exterior Finishing".
6. Remove the bolts at the wing base.
7. Open the front door and remove the bolt at the base of the front pillar.
8. Remove the upper wing bolts and wing.
Installation procedure
Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.
1. Install the wing using the upper wing bolts.
Tighten
Tighten the upper wing bolts to 10 Nm (89 lbs.in).
2. Install the bolt on the base of the front strut.
Tighten
Tighten the wing bolt on the front pillar with a force of 10 N·m (89 lbs.in).
3. Install bolts on the wing base.
Tighten
Tighten the lower wing bolts to 10 Nm (89 lbs.in).
4. Install the threshold panel molding. See section 9M, "Exterior Finishing".
5. Install the front fender bolts behind the front fascia.
Tighten
Tighten the front wing bolts to 10 Nm (89 lbs.in).
6. Install the front trim to its original position.
7. Install the bolts securing the front fascia to the fender.
Tighten
Tighten the front bolts securing the trim to the wing to 2.5 Nm (22 lbs.in).
8. Install the front wheel arch mudguard. Go to "Front wheel arch mudguard" in this section.