Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Threshold panel molding (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the front mudguards. See "Mudguards" in this section.

2. Release the clips and remove the threshold panel molding.

2. Release the clips and remove the threshold panel molding.

Installation procedure

1. Install the threshold panel molding using the fasteners.

2. Install the front mudguards. See "Mudguards" in this section.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Exterior (external elements)

Next articles

Roof Molding — Removal and Installation
Rear trim of the front side door glass frame
General description of exterior finishing
Glass of the outside rear view mirror
Exterior rear view mirrors

Mudguards — Removal and Installation
Front fender wheel opening molding
Rear wheel opening molding
Front side door lower molding
Rear side door lower molding

See similar articles on the topic of Chevrolet cars:
Instrument panel Chevrolet Aveo T300 (2012-2018)
Features of the instrument panel design Chevrolet Cruze 1 (2008-2016)
Removal the lower instrument panel trim Chevrolet Lacetti 1 (2002-2009)
Removal the instrument panel Chevrolet Lanos T150 (2002-2009)
Instrument panel Chevrolet Niva 1 (2002-2016)
Description of the instrument panel Chevrolet Tahoe 1 (1992-2000)
Removal and installation the heater and air conditioner control panel Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.