Front fender wheel opening molding (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the front mudguards. See "Mudguards" in this section.

2. Remove the screws and remove the wheel opening molding from the front fender.

Installation procedure

1. Install the wheel opening molding into the front fender and tighten the screws.

Tighten

Tighten the screws of the wheel opening molding in the front fender to 4 N·m (35 lbs.in).

2. Install the front mudguard

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Exterior (external elements)

Mudguards — Removal and Installation
Threshold panel molding
Roof Molding — Removal and Installation
Rear trim of the front side door glass frame
General description of exterior finishing

Rear wheel opening molding
Front side door lower molding
Rear side door lower molding
General description of the lower part of the body
Checking the installation angles (wheels). Checking the alignment (adjustment)

See similar articles on the topic of Chevrolet cars:
Possible faults of front wheel drives, their causes and methods of elimination Chevrolet Aveo T300 (2012-2018)
Design features of front wheel drives Chevrolet Cruze 1 (2008-2016)
Replacing the front wheel drive oil seal Chevrolet Lacetti 1 (2002-2009)
Front wheel drive device Chevrolet Lanos T150 (2002-2009)
Possible faults of the front wheel drive, their causes and methods of elimination Chevrolet Niva 1 (2002-2016)
Front wheel alignment angles Chevrolet Tahoe 1 (1992-2000)
Front Axle Shift Drive (All Wheel Drive Models with Electric Shift Drive) — Replacement Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)