Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Rear wheel opening molding (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the rear wheel opening molding.

1. Remove the rear wheel opening molding.

Installation procedure

1. Install the rear wheel opening molding.

[The original article can be found on the resource: «chevyman»]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Exterior (external elements)

Next articles

Front fender wheel opening molding
Mudguards — Removal and Installation
Threshold panel molding
Roof Molding — Removal and Installation
Rear trim of the front side door glass frame

Front side door lower molding
Rear side door lower molding
General description of the lower part of the body
Checking the installation angles (wheels). Checking the alignment (adjustment)
Engine mudguards

See similar articles on the topic of Chevrolet cars:
Removal and installation the rear wheel mudguard Chevrolet Aveo T300 (2012-2018)
Replacing the rear door opening limiter Chevrolet Cruze 1 (2008-2016)
Removal the rear wheel brake disc Chevrolet Lacetti 1 (2002-2009)
Adjusting the rear wheel bearings Chevrolet Lanos T150 (2002-2009)
Checking the rear brake wheel cylinders on the stand Chevrolet Niva 1 (2002-2016)
Rear Brake Wheel Cylinder — Removal, Disassembly and Installation Chevrolet Tahoe 1 (1992-2000)
Removal, repair and installation of the rear wheel brake cylinder Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.