Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Rear side door lower molding (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Unscrew the nut and remove the lower molding of the rear side door.

1. Unscrew the nut and remove the lower molding of the rear side door.

Installation procedure

1. Install the rear side door lower molding and tighten the nut.

Tighten

Tighten the rear side door lower molding nut to 4.5 N·m (40 lbs.in).

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Exterior (external elements)

Next articles

Front side door lower molding
Rear wheel opening molding
Front fender wheel opening molding
Mudguards — Removal and Installation
Threshold panel molding

General description of the lower part of the body
Checking the installation angles (wheels). Checking the alignment (adjustment)
Engine mudguards
General description of bumpers and trim
Schematic diagram of the parking assistance system

See similar articles on the topic of Chevrolet cars:
Side door locks Chevrolet Aveo T300 (2012-2018)
Replacing the inner handle of the rear door lock actuator Chevrolet Cruze 1 (2008-2016)
Removal the rear door trim Chevrolet Lacetti 1 (2002-2009)
Removal the rear door trim Chevrolet Lanos T150 (2002-2009)
Replacement of rear door glass Chevrolet Niva 1 (2002-2016)
Rear side door Chevrolet Tahoe 2 and 3 (2000-2014)
Removal and installation the rear door Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.