Front side door lower molding (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Unscrew the nut and remove the lower molding of the front side door.

Installation procedure

1. Install the front side door lower molding and tighten the nut.

Tighten

Tighten the front side door lower molding nut to 4.5 N·m (40 lbs.in).

The original text can be found on the website: «CHEVYMAN»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Exterior (external elements)

Rear wheel opening molding
Front fender wheel opening molding
Mudguards — Removal and Installation
Threshold panel molding
Roof Molding — Removal and Installation

Rear side door lower molding
General description of the lower part of the body
Checking the installation angles (wheels). Checking the alignment (adjustment)
Engine mudguards
General description of bumpers and trim

See similar articles on the topic of Chevrolet cars:
Side door locks Chevrolet Aveo T300 (2012-2018)
Replacing the inner handle of the front door lock actuator Chevrolet Cruze 1 (2008-2016)
Wiring diagram for front door electric windows Chevrolet Lacetti 1 (2002-2009)
Removal the front door trim Chevrolet Lanos T150 (2002-2009)
Data for checking the motor reducer of the front door electric windows Chevrolet Niva 1 (2002-2016)
Front side door trim panel Chevrolet Tahoe 2 and 3 (2000-2014)
Removal and installation front door glass Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)