Contents: Removal ↧ Installation ↧
Removal
1. Remove the side rearview mirror inner trim.
a) Using a screwdriver wrapped in protective tape, lift the inside trim of the side rear view mirror (1) by the edges and detach the clip (2) and holder (3) securing the trim to the door panel.
Escalade |
Besides Escalade |
b) If necessary, detach the retainer and holder from the trim.
2. Remove the window switch.
3. Lower the window glass.
4. Make sure that the door lock release button (1) is in the unlock position.
5. Using a flat-head screwdriver, press the lock release button holder and pull the button out in an upward motion.
6. Remove the door trim panel cover (2).
7. Unscrew the three screws (3) securing the panel.
8. Remove the cover (4) of the inner door opening handle facet.
9. Unscrew the three bolts (5) securing the door panel.
10. Disconnect the door wiring connector.
Note: There are two technological hooks at the bottom of the door trim panel, which are used during the assembly of the car at the factory, if these hooks are broken during removal or installation of the door trim panel, there is no need to replace the panel.
11. Pull out the lock cable holder (7).
12. Pull the panel (6) out of the clips (8), remove the panel.
Installation
13. Installation is carried out in reverse order.