Engine mudguards (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Raise and support the vehicle appropriately.

2. Remove the screws and engine mud shield.

Installation procedure

1. Install the engine mudguard using screws.

Tighten

Tighten the engine mudguard bolts to 10 Nm (89 lbs.in).

2. Lower the car.

(The article was reprinted from the website: ChevyMan.ru)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Exterior (external elements)

Checking the installation angles (wheels). Checking the alignment (adjustment)
General description of the lower part of the body
Rear side door lower molding
Front side door lower molding
Rear wheel opening molding

General description of bumpers and trim
Schematic diagram of the parking assistance system
Parking Assistance System Diagnostics
Front bumper trim
Front Bumper Energy Absorber

See similar articles on the topic of Chevrolet cars:
Removal and installation mudguards and engine crankcase protection Chevrolet Aveo T300 (2012-2018)
Removal and installation engine mudguards Chevrolet Cruze 1 (2008-2016)
Removal the engine compartment mudguards Chevrolet Lacetti 1 (2002-2009)
Starting the engine from another car's battery (jump-starting) Chevrolet Lanos T150 (2002-2009)
Starting the engine Chevrolet Niva 1 (2002-2016)
Starting a gasoline engine Chevrolet Tahoe 1 (1992-2000)
Engine bay and underbody of the car Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)