1. Raise the front of the vehicle and support it on stands. Remove the mudguard.
2. Disconnect the electrical connector from the drive unit.
3. Unscrew the mounting bolts and disconnect the drive unit from the intermediate shaft casing.
4. Installation is carried out in the reverse order of removal. Tighten the mounting bolts to the required torque.
The material was created based on information from the website: «CHEVYMAN.RU»
Front Axle Shift Drive (All Wheel Drive Models with Electric Shift Drive) — Replacement (Chevrolet Trailblazer 1)
The article was checked: Vladimir Romannikov
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Share information:
Previous articles
Trailblazer 1: Drive shafts and cardan
Next articles
Drive shaft boot (4WD models) — replacement
Drive shaft (4WD models) — removal and installation
Drive shafts (4WD models) — general information and inspection
Bridge (rear) removal and installation
Differential gear seal — replacement
Drive shaft (4WD models) — removal and installation
Drive shafts (4WD models) — general information and inspection
Bridge (rear) removal and installation
Differential gear seal — replacement
Intermediate shaft bearing housing seals (4WD models) — replacement
Intermediate shaft bearing housing (4WD models) — removal and installation
Intermediate shaft (4WD models) — removal and installation
Front Differential Holder — Removal and Installation
Differential seals (front, on all-wheel drive models) — replacement
Intermediate shaft bearing housing (4WD models) — removal and installation
Intermediate shaft (4WD models) — removal and installation
Front Differential Holder — Removal and Installation
Differential seals (front, on all-wheel drive models) — replacement
See similar articles on the topic of Chevrolet cars:
Removal the gear shift lever drive Chevrolet Aveo T200 (2003-2008)
Replacing the intermediate shaft seal of the front drive axle Chevrolet Captiva 1 (2006-2018)
Checking the accessory drive belt Chevrolet Cruze 1 (2008-2016)
Replacing the front wheel drive oil seal Chevrolet Lacetti 1 (2002-2009)
Front wheel drive device Chevrolet Lanos T150 (2002-2009)
Possible faults of the front wheel drive, their causes and methods of elimination Chevrolet Niva 1 (2002-2016)
Front axle shaft with housing (all-wheel drive models) — removal and installation Chevrolet Tahoe 1 (1992-2000)
Removal the gear shift lever drive Chevrolet Aveo T200 (2003-2008)
Replacing the intermediate shaft seal of the front drive axle Chevrolet Captiva 1 (2006-2018)
Checking the accessory drive belt Chevrolet Cruze 1 (2008-2016)
Replacing the front wheel drive oil seal Chevrolet Lacetti 1 (2002-2009)
Front wheel drive device Chevrolet Lanos T150 (2002-2009)
Possible faults of the front wheel drive, their causes and methods of elimination Chevrolet Niva 1 (2002-2016)
Front axle shaft with housing (all-wheel drive models) — removal and installation Chevrolet Tahoe 1 (1992-2000)
Link in different formats to this page
Visitor comments
No comments yet
- General information
- Introduction to manual
- User manual
- Maintenance
- Troubleshooting
- Power unit
- Engine repair
- Fuel and control system
- Cooling and lubrication system
- Ignition system
- Transmission
- Clutch
- Gearbox
- Drive shafts
- Chassis
- Car suspension
- Steering
- Brake system
- Body
- Exterior (external elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Windscreen wipers
- Power devices
- Electrical diagrams
- General information
- User manual
- Troubleshooting
- Maintenance
- Power unit
- Engine in a car
- Engine overhaul
- Cooling and heating
- Fuel and exhaust system
- Engine electrical equipment
- Engine control
- Transmission
- Automatic gearbox
- Transfer case
- Drive shafts and cardan
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Exterior (external elements)
- Interior (internal elements)
- Doors, locks and windows
- Electrical equipment
- Equipment and devices
- Electrical circuits
- General information
- Maintenance
- Power unit
- Engine 3.1L V6
- Engine 3.8L V6
- Engine overhaul
- Cooling system
- Power and exhaust system
- Fuel injection
- Engine electrical equipment
- Reduced exhaust gas toxicity
- Transmission
- Automatic gearbox
- Drive shafts
- Chassis
- Brake system
- Car suspension
- Steering
- Body
- Heating and air conditioning
- Repair of body elements
- Doors, covers and windows
- Interior (internal elements)
- Electrical equipment
- Equipment and devices
- Electrical circuits