Removal the gear shift lever drive (Chevrolet Aveo T200)

Removal

1. Remove the rod clamp.

2. Release the universal joint clamp.

3. Separate the cardan joint from the gearbox.

4. Remove the locking shaft pin and separate the linkage connecting piece from the rear transmission mounting bracket.

Remove the shift linkage assembly.

Installation

Assemble in the reverse order of disassembly.

Adjust the shift linkage.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Aveo T200: Manual gearbox

Removal and installation the gearshift housing
Removal and installation the gear shift lever
Adjusting the gear shift mechanism
Gearshift mechanism drive
The device of a five-speed manual gearbox (D16)

Replacing the wheel drive shaft seal
Removal and installation of gearbox
Disassembly and assembly of manual transmission
Transmission drive (input) shaft
Driven (output) shaft of the transmission

See similar articles on the topic of Chevrolet cars:
Gear shift lever housing Chevrolet Captiva 1 (2006-2018)
Checking the accessory drive belt Chevrolet Cruze 1 (2008-2016)
Removal the gear shift control mechanism Chevrolet Lacetti 1 (2002-2009)
Replacing the alternator drive belt Chevrolet Lanos T150 (2002-2009)
Adjusting the bearings of the drive gear of the gearbox Chevrolet Niva 1 (2002-2016)
Gear Shift Lever — Removal and Installation Chevrolet Tahoe 1 (1992-2000)
Gear Shift Lever Neutral Position Sensor Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet