Withdrawal procedure
1. Disconnect the cable from the negative battery terminal.
2. Remove console. See Section 9G, Interior lining.
3. Disconnect the shift control cables from the shift lever housing. See «Shift cable» in this section.
4. Remove the nuts from the shift lever housing.
5. Remove the shift lever housing.
Installation order
1. Install the shift lever housing.
2. Install the nuts on the shift lever housing.
Tighten
Tighten the gear lever housing bolts to 8 Nm (71 lb-in).
3. Connect the shift cables to the shift lever housing and adjust the cable. See «Shift cable» in this section.
4. Install the console. See Section 9G, Interior lining.
5. Connect the wire to the negative terminal of the battery.