2. Remove the mudguard.
3. Remove the right drive shaft (see subsection 12).
4. The outer seal can be replaced without removing the bearing housing. Using a special tool, pry up and remove the oil seal. You can also use an impact tool with a seal removal attachment for this purpose. Using a mandrel or socket head with a diameter slightly smaller than the diameter of the seal, insert the seal into the socket.
Caution: The seal must be inserted so that it is in the hole at a depth of 9-11 mm, otherwise the seal may be damaged by the intermediate shaft.
5. To replace the inner seal (located on the pallet side), it is necessary to remove the casing (see subsection 16). Clamp the intermediate shaft casing in a vice with pads, then, using a special device, remove the oil seal from the socket. You can also use an impact tool with a seal removal attachment for this purpose. Using a mandrel or socket head with a diameter slightly smaller than the diameter of the seal, insert the seal into the socket.
6. Install the bearing housing if necessary.
7. The rest of the assembly procedure is carried out in the reverse order of removal.