Filler cap (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the screws and filler cap.

Installation procedure

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

1. Install the filler cap using screws.

Tighten

Tighten the filler cap screws to 4 Nm (35 lbs.in).

[Information taken from the official website CHEVYMAN]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Exterior (external elements)

General description of the rear part of the body
Front wing insulation
Front engine shield
Front wing — removal and installation
Front wheel arch trim

Rear wheel arch trim

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)