Radiator grille — removal and installation (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Open the hood.

2. Remove the nuts and radiator grille.

Installation procedure

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

1. Install the radiator grille using nuts.

Tighten

Tighten the radiator grille nuts to 4.5 Nm (40 lbs.in).

2. Close the hood.

The source of the article is available on the website CHEVYMAN.RU

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Exterior (external elements)

Hood insulation — removal and installation
Hood lock drive cable
Main bonnet latch support
Bonnet struts — removal and installation
Hood hinges — removal and installation

Radiator grille guide
Front wheel arch trim
Front wing — removal and installation
Front engine shield
Front wing insulation

See similar articles on the topic of Chevrolet cars:
Radiator grille Chevrolet Aveo T250 (2006-2011)
Removal and installation the electric fan of the radiator of the cooling system Chevrolet Cruze 1 (2008-2016)
Removal the radiator grille Chevrolet Lacetti 1 (2002-2009)
Removal the radiator fans Chevrolet Lanos T150 (2002-2009)
Radiator — removal and inspection Chevrolet Niva 1 (2002-2016)
Radiator grille — removal and installation Chevrolet Tahoe 1 (1992-2000)
Radiator grille — removal and installation Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)