You will need: TORX T20 and "10" keys.
1, Remove the front door trim and moisture-proof film (see "Removal and installation the front door trim").
2. Loosen the two nuts securing the glass in the window lifter slider housings (see "Front door glass replacement").
3. Fix the glass in the extreme upper position by inserting a rod of suitable diameter into the hole in the door panel.
Helpful hint: You can fix the glass, for example, using a screwdriver, pieces of PVC pipe of a suitable diameter, or masking tape.
4. Remove the five bolts securing the window regulator to the door panel.
For ease of removal and installation, the window regulator mounting bolts A do not need to be completely unscrewed. It is enough to loosen them and, lifting the window regulator, remove first one and then the second bolt from the grooves.
5. Remove the window regulator from the door cavity through the mounting hole in its inner panel.
6. Use a screwdriver to press the wiring harness connector lock...
7. ...disconnect the wiring harness connector from the window lifter motor...
8. ...and finally remove the window regulator.
9. Remove the three screws securing the gear motor...
10. ...and remove the gear motor.
11. Install the window regulator and all removed parts in the reverse order of removal.