Removal and installation the coolant reservoir (Chevrolet Lumina 1)

1. Disconnect the reservoir hose from the radiator neck (see illustration 5.4e).

5.4e. Disconnect the expansion tank hose from the radiator neck

2. Loosen the mounting screws (see illustration) and remove the tank from the car. Be careful not to spill coolant on the painted surfaces of your vehicle. Installation is carried out in reverse order.

6.2. Loosen the mounting screws (indicated by arrows), to remove the expansion tank

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Lumina 1: Cooling system

Removal and installation the radiator
Replacing the engine cooling fan motor
Replacing the engine cooling fan
Troubleshooting the Cooling Fan Control Circuit
Checking the engine cooling fan motor

Checking the coolant pump
Removal and installation the coolant pump
Checking and replacing the coolant temperature sensor

See similar articles on the topic of Chevrolet cars:
Checking the level and adding coolant Chevrolet Aveo T300 (2012-2018)
Engine coolant temperature gauge Chevrolet Captiva 1 (2006-2018)
Checking the level and adding coolant Chevrolet Cruze 1 (2008-2016)
Checking the fluid level in the windshield washer reservoir Chevrolet Lacetti 1 (2002-2009)
Checking the fluid level in the windshield washer reservoir Chevrolet Lanos T150 (2002-2009)
Filling the cooling system with coolant Chevrolet Niva 1 (2002-2016)
How to add coolant to the reservoir Chevrolet Tahoe 1 (1992-2000)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet