Rear flap door sealer (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Open the rear hatch.

2. Pull the seal out of the groove.

Installation procedure

1. Install the seal on the groove flange.

2. Check the sealer. Make sure that the bracket (clamp) is fully attached to the flange.

3. Install a new seal onto the groove flange.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Doors and windows

Tailgate exterior handle
Rear Tailgate Latch Lock
Rear Tailgate Latch
Rear Tailgate Pillar
Rear drop door

Upper decorative molding for rear hatch glass
Side decorative molding for rear hatch glass
Rear tailgate lower trim
Rear Tailgate Glass Pillar
Rear Tailgate Glass Latch

See similar articles on the topic of Chevrolet cars:
Replacing the inner handle of the rear door lock actuator Chevrolet Aveo T300 (2012-2018)
Replacing the inner handle of the rear door lock actuator Chevrolet Cruze 1 (2008-2016)
Removal the rear door trim Chevrolet Lacetti 1 (2002-2009)
Removal the rear door trim Chevrolet Lanos T150 (2002-2009)
Replacement of rear door glass Chevrolet Niva 1 (2002-2016)
Rear door (Cadillac Escalade, Chevrolet Tahoe) Chevrolet Tahoe 2 and 3 (2000-2014)
Removal and installation the rear door Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)