Contents: Interior trim panels ↧ Pressure equalization hole ↧ Floor console ↧ Floor carpeting ↧ Tightening torques for threaded… ↧ Special tools ↧
Interior trim panels
The interior trim panels are made of injection molded plastic and are secured with screws and plastic fasteners.
Pressure equalization hole
When all windows are closed and the ventilation system is on, the supply of outside air to the inside of the car causes positive pressure inside it. To relieve this pressure, air is released through the pressure equalization vent. The pressure equalization vents are located at the rear of the car under the bumper.
Floor console
The floor console is mounted above the tunnel in the car's floor and extends from the center of the instrument panel to the rear seat area. The front of the console contains the cigarette lighter and gearshift lever. The rear of the console contains the parking brake lever, cup holder, storage compartment, and ashtray for rear seat passengers.
Under the console are the airbag system's sensor diagnostic module (SDM) and the keyless entry module.
Floor carpeting
A full-length carpet covers the front and rear floor panels.
Tightening torques for threaded connections
|
PROGRAM
|
Nm
|
pound-foot
|
pound-inch
|
|
Windshield Decorative Molding Screw
|
2
|
-
|
18
|
|
Screw for lower decorative molding of the central pillar
|
22
|
16
|
-
|
|
Rear Quarter Glass Decorative Molding Screw
|
2
|
-
|
18
|
|
Floor Console Bolts
|
8
|
-
|
71
|
|
Front Console Holder Screw
|
2
|
-
|
18
|
|
Mounting screw for hood release handle
|
3
|
-
|
27
|
|
Rear storage tray bolts
|
8
|
-
|
71
|
|
Rear wheel arch trim panel screws
|
2
|
-
|
18
|
|
Driver's knee bolster screws
|
2.5
|
-
|
23
|
|
Driver's knee bolster bolts
|
20
|
15
|
-
|
Special tools
KM-475-B
Upholstery remover