Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Disconnect the negative battery cable.
2. Remove the driver's knee bolster. See section 9G, "Interior Trim".
3. Turn the ignition key to the "ON" position.
4. Disconnect the electrical connector.
5. Remove the ignition switch mounting screws.
Installation procedure
1. Install the ignition switch mounting screws.
Tighten
Tighten the ignition switch mounting screws to 2.5 N·m (22 lbs.in).
2. Connect the electrical connector.
3. Install the driver's knee bolster. See section 9G, "Interior Trim".
4. Connect the negative battery cable.
[The article was borrowed from the website: ChevyMan.ru]