Hood — removal and installation (Chevrolet Captiva 1)

Removal procedure

Important: Install protective covers on fenders and windshield to avoid damage to paint, glass and moldings when removing and installing the hood.

1. Raise and support the hood.

2. Mark the position of the hinge on the hood to aid in alignment during installation.

3. Remove the washer hoses from the hood.

4. Remove the hood pillars. See "Hood struts" in this section.

5. Remove the bolts securing the hood to both hinges.

6. With the help of another mechanic, remove the hood from its hinges.

Installation procedure

1. With the help of another mechanic, install the hood in the location marked during removal.

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

2. Install two bolts securing the hood to each hinge.

Tighten

Tighten the bolts securing the bonnet to the hinges to 24 Nm (18 lb-ft).

3. Install the hood struts. See "Hood struts" in this section.

4. Check that the hood is properly aligned.

5. Install the washer hoses onto the hood.

The article is based on data from the website ChevyMan