Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Disconnect the cable from the negative battery terminal.
2. Remove the rear bumper trim. Go to "Rear bumper trim" in this section.
3. Disconnect the sensor connector.
4. Remove the rear obstacle warning sensor from the rear bumper trim by rotating the holder.
Installation procedure
1. Install the rear obstacle warning sensor to the rear bumper trim by rotating the holder.
2. Connect the sensor connector.
3. Install the rear bumper trim. Go to "Rear bumper trim" in this section.
4. Connect the cable to the negative terminal of the battery.
(The material was created based on information from the website chevyman.ru)